D Class, mono amplifier, able to deliver 1000 W into 1 ohm and Compatible with factory OEM car audio systems, thanks to the Speaker-In hi-level input and Signal Sense turn-on/off features. The SRx 1D can also generate a PRE-amp output signal to accommodate system expansion. With the SRx 1D, Audison introduces the "Amp Chain Mode" function. Inherited from the LRx line, this technology provides the ability to "cascade" many amplifiers together, extending the available power to infinite levels, as well as controlling the whole group of amplifiers through one set of controls found on the appointed "master" amplifier.

It’s one of the most complete and refined stereo amplifiers with regards to signal handling: its crossover section has independent hi-pass/lo-pass filters. You can adjust Q factor in the hi-pass section while lo-pass filter can be configured in stereo (12 dB/Oct) or mono (24 dB/Oct). Crossover can be completely bypassed in oder to use SRx 2S as a standard stereo amplifier. There are front and sub inputs, both pre-in and "speakers-in". There is also a bypass pre output with hi-pass/lo-pass/bypass switch.

Very specialised amplifier, designed for front+sub system. Its electronic features make it far more performing than any other four channel amplifiers used in the traditional configuration with two of the four channels in bridge on the subwoofer: damping factor stays very high and you can drive 2Ω load. Thus, it has much higher power and control capacity than similar amplifiers. SRx 3 has a 50 Hz bass boost switch (0/+2/+4 dB) and bypass pre outputs.

Ideal for factory sound systems, SRx 2 insures uncommon functionality and performances. It can replace or complete the amplification of whatever sources, including factory systems ones. Thanks to “speakers-in” inputs, it can be used even with sources that don’t have a preamplified output. Thanks to its bypass built-in crossover, SRx 2 is also ideal for driving additional subwoofer sections.

Front/rear or front/sub amplifier with built-in crossover. Front channels filter can be hi-pass or full range, rear channels one can be hi-pass, lo-pass or full range. SRx 4 can be used as a 4/3/2 channel amplifier. When you choose 2 channel configuration (left/right), you can use hi-pass, lo-pass or full range functioning. There are "speakers-in" front/rear inputs and a bypass output.

Fully configurable front/rear/sub amplifier. Its refined crossover section allows its use also in multichannel configuration when you like to realise very good systems with active amplification for tweeters, midwoofers (band-pass) and subwoofers. When you need very high powers, you can use SRx 5 even in three channel configuration. It has separate pre-in or "speakers-in" inputs for front/rear/sub.